Lloyd,
We have converted about 200 PADs files in the past several months. Of the
few that I actually used, the only massaging we made was manufacturing
design rules and gnd plane assignment. Very minor problems. The
conversion process, as close as I can tell is seamless. You will need to
start with the PADS ascii formats, not the pcb file
Mike Reagan
EDSI
> -----Original Message-----
> From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
> Sent: Monday, September 17, 2001 10:53 AM
> To: Protel EDA Forum
> Subject: Re: [PEDA] PADs conversion
>
>
> Hello all,
> Has anyone had any success in converting old (versions 2 & 3) PADs files
> into Protel?
> We have a company that we purchased whose old files are in these
> formats and
> need some conversion utility to do many file conversions.
> Please advise.
>
> Lloyd Good
> Engineering Systems Co-ordinator
> GE Substation Automation Systems
> 2728 Hopewell Place NE
> Calgary, Alberta, Canada
> T1Y 7J7
> Tel: (403) 214-4777
> Fax:(403) 287-7946
> email: [EMAIL PROTECTED]
>
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
