*******************************************************
Todays forums are sponsored by Ian Martin Limited
Engineering/Technical Placement Specialists
www.ianmartin.com
*******************************************************

Mariano
    If you use only one layer to route a board, make sure that you use the
solder side if you
    have holes in the board, or the drill files will not generate without extra
work.
Bob Fearon


Ben Uytenhaak wrote:

> >Hi again, how can i create a PCB WIZARD with only one layer?? I've
> >Protel 99 SE
>
> Mariano,
>
> As far as I know the PCB wizard is not able to generate a one layer pcb.
> I think you should create a two layer board and than disable routing on one
> of both layers.
> Design Rules -> Routing -> Routing layers, and set the layer you don't want
> to "Not Used"
> I Hope this helps.
>
> Ben Uytenhaak
> [EMAIL PROTECTED]
>
> Gatsometer BV
> P.O. Box 4959
> 2003EZ  Haarlem
> The Netherlands
>
> phone : +31 23 5255050
> fax : +31 23 5276961
> -----Original Message-----

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to