I have a large 8 page schem with many multi part components

annotate splattered the multi part groupings all over the place much as
might be expected

noticing the 'group parts together if match by' in the annotate dialog
i went and put GRP1 in part field 8 for one section and GRP2 in the next
and so forth

when i ran the annotation using 'group parts together' by BOTH Part Type
and Field 8, it made a bigger and potentially worse mess

it did not honor the part type at all! 
so res network 4.7K was RN2 and so was res network 100K RN2 !

this is pretty bad IMHO

has anyone actually made this work?

if 2 parts have different part types and the same group by field content
shouldn't that work?

i suppose i could put different strings in field 8 for different parts,
but i suppose i could manually annotate the thing too!

Dennis Saputelli

-- 
___________________________________________________________________________
www.integratedcontrolsinc.com            Integrated Controls, Inc.    
   tel: 415-647-0480                        2851 21st Street          
      fax: 415-647-3003                        San Francisco, CA 94110

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to