I received this question from an associate who is evaluating the Protel
Software and thought I should post it to the forum. Your thoughts? 
----------------
Do you use the signal analysis on Protel?  If so, how well does it work?
We're finally getting up high enough that we've started checking the
signals, so a couple of the engineering were wondering about that
capability.
------------

Bill Brooks 
PCB Design Engineer , C.I.D.
DATRON WORLD COMMUNICATIONS, INC
3030 Enterprise Court 
Vista, CA 92083 
Tel: (760)597-1500 Ext 3772 Fax: (760)597-1510 
mailto:[EMAIL PROTECTED] 
IPC Designers Council, San Diego Chapter 
http://www.ipc.org/SanDiego/
http://home.fda.net/bbrooks/pca/pca.htm

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to