Thanks Steve, you pointed me to a place of hope for resolving the
current problems I have in getting working the SI tool - I thought!

I downloaded and installed the manual and had a quick look to it. Up to
now I have the impression that they try to do something like to teach
walking to Carl Lewis! No word found about the SI tool so far :-(

Maybe that some of you folks can help me. I'm trying to run the SI on a
design built up of all "self made" librarys (in Schematic as well as in
PCB). I have set up appropriate design rules and defined some designator
map. Although my PC is occupied quite for a while after starting SI I
have the impression that no simulation is performed. I always get no DRC
errors. With no errors the reflection analysis can't be started if I
understand this point well. but exactly this is what I want to do. I
have a prototype board that under certain circumstances let hang the
processor. I now intended to simulate the critical pathes on the board
regarding signal integrity (I'm quite sure that this is the cause).

Any help and hints from more or less experienced SI users is
appreciated!

TIA,
Emanuel 


-- 

%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
MPL AG                      www.mpl.ch
Emanuel Zimmermann          [EMAIL PROTECTED]
Manager R&D                 Phone: +41 (0)56 483 34 34
Taefernstrasse 20           Fax:   +41 (0)56 493 30 20

CH-5405 Daettwil
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to