Does anyone know if it is possible (or how to) set a design rule to check
between the overlay and the soldermask layers?  If you place a designator
over a pad or via then it does not appear correctly on the finished PCB.  I
have simplified the solution to check the reference designators versus the
[inverted] soldermask of the same side and make sure they don't overlap.  I
was hoping to automate the process with a design rule.  Any ideas?

Anthony Whitesell
Sunrise Labs

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to