The settings are stored in a [schematic_name].cfg file, which usually is located in the same folder as the schematic (when using the ddb-system).
Rolf Molitor Ing.Buero i2e Remscheid/Germany -----Urspr�ngliche Nachricht----- Von: "Jason Morgan" <[EMAIL PROTECTED]> An: "Protel EDA Forum (E-mail)" <[EMAIL PROTECTED]> Gesendet: Dienstag, 15. Januar 2002 12:46 Betreff: [PEDA] Simulation Setup > Hi, > > I've used the Protel SPICE Simulator many times in the past, but not for a > while. > > Just come to do an AC analysis of a filter and the Simulation Setup dialogue > box > ignores my instructions. > > I know I've had this problem before, just can't remember how to fix it. > I seem to remember it writes a file containing the settings in the dialogue > for > passing to the simulator, just can't remember where..... > > I do: > Simulation->Setup->Check AC Analysis > Close Dialogue, Open it again > > The setting is cleared. > > I recall this can happen if for some reason it can't write the file, just > can't remember if this > is the truth and if so what and where the file is - any clues? > > > Jason. * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
