Associative Dimensioning = Equalize Trace Length?

To implement the equalize netlengths feature, you have to define a netclass with
the nets you want to equalize. Then go to Design Rules/High Speed/Matched Length
 and set the attributes. Depending on how much room on the board you have, set
the
amplitude and gap for the largest that can be fitted. Then run Tools/Equalize
Net Length
 a couple of times to progressivly add sections.

Usually a couple of runs are required as Protel only 'adds' 1 section at a time.
It works
out which net in the netclass is the longest and adds sections to the other nets
to bring
them up. The amplitude and gap can be reduced in later runs to have a finer
tolarence.
You can then do a DRC to check the lengths. It all works suprisingly well.



_______________________________________________________________

Clive Broome
IDT Sydney Design Centre        Ph:         +61 2 9763 3513
8 Bayswater Dr, Homebush        Fax:        +61 2 9763 3409
Sydney,  NSW, 2127              Email:[EMAIL PROTECTED]
Australia
_______________________________________________________________






"Brian Sherer" <[EMAIL PROTECTED]> on 01/25/2002 01:23:27 PM

Please respond to "Protel EDA Forum" <[EMAIL PROTECTED]>

To:   "Protel EDA Forum" <[EMAIL PROTECTED]>
cc:    (bcc: Clive Broome/sdc)

Subject:  [PEDA] Length of Selection



Thanks to Phil and Mark - found it with no problem. I'll have
to check the list of tools carefully; maybe there's a tool for
Associative Dimensioning hidden in there.....:)

Brian








* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to