Hey all,
        I was looking over a board route of mine and noticed that there are a lot
of via's that are very close to pads which could bridge during soldering.
Is there any rule specifically to control via to pad distance.  I know the
clearance rule will move them away but it also makes the traces need a lot
more room as well which is not a possibility.

Afshin Salehi
DPS Telecom

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to