On 10:47 AM 31/01/2002 -0800, Afshin Salehi said:
>Hey all,
>         I was looking over a board route of mine and noticed that there 
> are a lot
>of via's that are very close to pads which could bridge during soldering.
>Is there any rule specifically to control via to pad distance.  I know the
>clearance rule will move them away but it also makes the traces need a lot
>more room as well which is not a possibility.
>
>Afshin Salehi
>DPS Telecom

Add a new clearance rule with Scope A set to vias and Scope B to pads and 
then set your desired clearance.

Then re-run batch DRC.

Ian Wilson

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to