At 07:53 PM 5/02/02 -0600, you wrote:
>I am trying to set component clearance rules to allow small
>components to overlap the bounding box of larger components
>or oddly shaped components. As an example allowing surface
>mount filter caps to sit tightly against the pins of a TO-220.
>Setting negative clearance between the 2 classes of components
>does not seem to accomplish this.
>
>         Jayhawk Design
>-- Pat Lyons, [EMAIL PROTECTED] on 02/05/2002

No Can Do.

Negative clearances on components do not work - would be nice if they 
did.  Alternatively a rule that allowed component clearance violations to 
be ignored for specific components or regions would be helpful.

Ian Wilson

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to