You don't directly. Read Mr. Lomax's previous email. You have to go the 3.0
route and load P98 to back it up even further.

Tony


> -----Original Message-----
> From: Peder K. Hellegaard [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, February 14, 2002 1:23 PM
> To: Protel EDA Forum
> Subject: [PEDA] SV: Exporting ASCII
>
>
> As the matter of fact, what I want to export in ASCII format is the
> libraries (SCH and PCB). How is that done ??
>
>
> Peder
>
>
>
>
> -----Oprindelig meddelelse-----
> Fra: Abd ul-Rahman Lomax [mailto:[EMAIL PROTECTED]]
> Sendt: 14. februar 2002 21:19
> Til: Protel EDA Forum; Protel EDA Forum
> Emne: Re: [PEDA] Exporting ASCII
>
>
> At 11:38 AM 2/14/2002 -0800, Tony Karavidas wrote:
> >Open the PCB in 99SE, then go to File-Export. The "Save as type"
> field has
> a
> >few options; the last one is Protel PCB 2.8 ASCII file.
>
> I'm missing that option. Clues why?
>
> Oops, just looked. I kept looking at Save As, not Export.... Yes, it is
> there under File/Export. What was taken out was Autotrax export which was
> still in Protel 98 as I recall.
>
> That is quite a decent pause before dropping direct backtranslation
> support.... Congratulations, Protel.
>
> [EMAIL PROTECTED]
> Abdulrahman Lomax
> Easthampton, Massachusetts USA
>


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to