If you want to import from the PADS v3.0 (DOS app), you need to import the
PADS .ASC (ASCII) file into Protel v3.X.  Then you can save it as a Protel
file and bring it into 99SE or whatever.

Best regards,
Ivan Baggett
Bagotronix Inc.
website:  www.bagotronix.com


----- Original Message -----
From: "Frank Gilley" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Thursday, March 21, 2002 4:49 PM
Subject: Re: [PEDA] Importing Pads to Protel


> Abdulrahman,
>
> >I did translate a PADS file once and it worked. But it was some time ago
> >and I don't know what version. I'd be a little surprised, in fact, if
> >Protel could import Pads 3.0, but someone else will probably know better.
>
>  From the Protel PADS translator readme:
>
> The translator imports the following PADS PCB ASCII file formats:
>     PowerPCB V1, V1.1, V1.5, V2, V3.0, V3.5
>     PADS Perform
>     PADS 2000 V3, V4
>     PADS PCB V5
>
> Thanks for the information about the .dsn file, I was able to successfully
> translate that!
>
> Thanks again,
>
> Frank
>
>
>
>
> Frank Gilley
> Dell-Star Technologies
> (918) 838-1973 Phone
> (918) 838-8814 Fax
> [EMAIL PROTECTED]
> http://www.dellstar.com
>

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to