If you really need it, you could always use a manually routed line above
comment, designator or text strings.

Tom.

> -----Original Message-----
> From: Geoff Harland [mailto:[EMAIL PROTECTED]]
> Sent: Tuesday, 2 April 2002 3:15 PM
> To: Protel EDA Forum
> Subject: Re: [PEDA] Text
> 
> 
> > I know that you can put lines over pin names on schematic symbols to
> denote
> > an inverted signal. Can this be done on PCB part types & 
> text strings?
> >
> > Sean James
> 
> In short, no. The feature provided in the Schematic editor 
> has presumably
> been provided for use with physical printouts (though, 
> somewhat ironically,
> this aspect is not without problems).
> 
> I can see some merit in Net identification (for pads and vias) being
> displayed in a similar manner in PCB files, but speaking 
> personally, I would
> not place a high premium on having that feature implemented.
> 
> Again speaking personally, I don't see much merit in being 
> able to place
> overbars on general text string objects in PCB files. That 
> said, I concur
> that others might see things differently in that regard.
> 
> Regards,
> Geoff Harland.
> -----------------------------
> E-Mail Disclaimer
> The Information in this e-mail is confidential and may be legally
> privileged. It is intended solely for the addressee. Access to this
> e-mail by anyone else is unauthorised. If you are not the intended
> recipient, any disclosure, copying, distribution or any action taken
> or omitted to be taken in reliance on it, is prohibited and may be
> unlawful. Any opinions or advice contained in this e-mail are
> confidential and not for public display.
> 
> 

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to