My current design has the following rule clearance (Board) to (Board) Different Nets Gap 7mil
but for manufacturing purpose i need an additional rule clearance (Smd Pad) to (Smd Pad, Via) Any Net Gap 10mil both rules are marked as Rule Followed by Router in P99SE SP6 but in fact the router ignores the second rule and after autorouting is finished i get lots of drc errors and the design need some handmodifications. (YES i do lots of the routing job by hand ......) is there any chance in getting the router doing the job by following both rules ? regards Dipl.-Ing. (FH) Michael Schmitt Baumer Ident GmbH Entwicklung / Development Department Hertzstr. 10 D-69469 Weinheim Deutschland / Germany Tel. +49 (0) 6201 9957 - 30 Fax. +49 (0) 6201 9957 - 99 E-Mail : [EMAIL PROTECTED] Web: http://www.baumerident.com sdcc * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/proteledaforum@techservinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *