Rene,
        did you have auto-back-ups enabled? If so then you should search the
drive (assuming it is not complete toast) for "PCB filename".bk1, "PCB
filename".bk2, etc., to the maximum number of backups you had specified. I
hope that you did not turn off the Protel generated back-ups! I even set a
specific directory to receive these back-ups so that they are in a unique
location and they are all that is found in that directory.

        I am not sure what your comment below was directed at. I took it to
mean system back-ups and not the Protel automatic back-ups.

Sincerely,
Brad Velander.

Lead PCB Designer
Norsat International Inc.
Microwave Products
Tel   (604) 292-9089 (direct line)
Fax  (604) 292-9010
email: [EMAIL PROTECTED]
http://www.norsat.com

Visit us at Booth 2G2-09 at CommunicAsia 2002 in Singapore June 18-21.


> -----Original Message-----
> From: Rene Tschaggelar [mailto:[EMAIL PROTECTED]]
> Sent: Monday, April 29, 2002 8:33 AM
> To: Protel EDA Forum
> Subject: Re: [PEDA] recovering data
> 
> 
> Thanks, but the drive crashed. And backup was a bit behind.
> 
> Rene
> 

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to