If you go to the Design Menu and select Netlist Manager there is a button
labeled "Menu" in the lower left corner.  Click that and then select "Update
Free Primitives From Component Pads" and that will update all unassigned
primitives (tracks, vias, etc.).

Beware that if there are any misconnected tracks (connected to more than one
net) it will get confused and not know which net to assign.

Hope this was of some help.

Regards,

Cliff

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Cliff Gerhard, P.E.
Director - EE Group
E-M Designs, Inc.
32122 Camino Capistrano
Suite 200
San Juan Capistrano, CA 92675
PH 949.661.3016 x 501
FX 949.661.3017
www.GerhardEng.com
www.emdesigns.com
www.emmanufacturing.com


-----Original Message-----
From: Rene Tschaggelar [mailto:[EMAIL PROTECTED]]
Sent: Friday, May 03, 2002 8:49 AM
To: Protel EDA Forum
Subject: [PEDA] propagate net


I have unassigned tracks (no net) and would like to proagate
the connected net.
In schematic there is a 'design/update pcb' that has a checkbox
for 'Assign net to connected copper'. That somewho does not appear
to work.

Now ( in pcb editor )  I have do :
-edit/select connected copper
-read the netname from the source
-doubleclick one new track item
-change net to new net with global, selection same

Is that all possible on one click per track ?

Is that possible on one click for the whole board ?

Rene
--
Ing.Buero R.Tschaggelar - http://www.ibrtses.com

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to