Thank to all for these quick replies.
The netlist manager solved it. I didn't try to propagate
through unassigned vias, since they usually don't pick up the
changes in net assignment. So I did repeat {assign, place via} 
until all nets were completely assigned.

I made a section on a page describing the procedure :

http://www.ibrtses.com/software/protel99se.html

Rene


Rene Tschaggelar wrote:
> 
> I have unassigned tracks (no net) and would like to proagate
> the connected net.
> In schematic there is a 'design/update pcb' that has a checkbox
> for 'Assign net to connected copper'. That somewho does not appear
> to work.

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to