Hi Kat,

Do Edit->Paste special and tick on Duplicate designators. Tick off Keep Net Name. You 
could also do Paste Array.

Igor

-----Original Message-----
From: Katinka Mills [mailto:[EMAIL PROTECTED]]
Sent: Sunday, 11 August 2002 9:48 PM
To: Protel EDA Forum
Subject: [PEDA] P99SE lockups


Hi all,

I am just starting to have problems with P99SE, I have a design, it is a
simple 2 layer board, but it is having problems :

#1 Auto Routing crashes protel on this design. (Access violation)

#2 Routing one net at a time, causes the entire board to be routed and
crashes protel. (Acess violation) Not sure why it does the whole board when
all I asked it to do was one board.

Also does anyone know how to panalise in P99SE (not a gerber as the fab shop
wants it in P99SE format, but I have to panalise the 2 designs) I tried to
make an outine of the panel and then cut and paste the PCB's in the panel,
but all my component ID's change eg R4 may be come R4_3_1 etc.

Regards,

Kat.

**********************************************
K.A.Q. Electronics.
Electronic and Software Engineering.
Perth, Western Australia.
Ph +61 (0) 419 923 731
**********************************************
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.381 / Virus Database: 214 - Release Date: 2/08/2002


************************************************************************
* Tracking #: 7D6125021AA88C479868EF45654F4555BFC8908D
*
************************************************************************

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to