sure just put a board in there set up that way
we use a couple of different ones

Terry Creer wrote:
> 
> Hi all,
>         A few days ago there was a thread on setting up the default.tdb to
> set up my default database every time I start up a new database. Is there a
> way to change the default design rules, snap grids, layers etc every time I
> start a new PCB document (or schematic for that matter)? I'm sick of
> changing the default settings every time I create a new document... :(
> 
> Cheers
> 
> TC
> 
>-- 
___________________________________________________________________________
www.integratedcontrolsinc.com            Integrated Controls, Inc.    
   tel: 415-647-0480                        2851 21st Street          
      fax: 415-647-3003                        San Francisco, CA 94110

************************************************************************
* Tracking #: 39239B8BDD7E414AA01872D442402A4706B14B8D
*
************************************************************************

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to