Never mind. I found the problem. Thank you.

>  -----Original Message-----
> From:         Shuping Lew  
> Sent: Wednesday, October 09, 2002 2:44 PM
> To:   '[EMAIL PROTECTED]'
> Subject:      Fan out vias from surface mount component pads
> 
> Hi, all,
> 
> Does anybody know a good way to fan out SMD pins? How many Protel
> users use Protel Auto Router fan out pass? I have been doing it
> manually. It is just too much work. 
> 
> I tried Auto Route/setup/setting, selected Fan out used SMD pins only,
> Then Route all...but it did not work. Nothing happen. Design rules
> were set for 13/30 for via, 7mil trace w/ 6 mil clearance, and top and
> bottom layers only. Why doesn't it work? Am I missing something? 
> 
> I am using Protel 99SE.
> 
> 
> Thank you for any reply... 
> 
> 
> 
> Shuping Lew
> 
> 
> Quintron Systems, Inc.
> 

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to