Greetings,

A colleague had this experience:

Created some components in DXP then sent the PCB document to a third party using an earlier version (don't know which) and then returned the document to DXP - the components he built in DXP had the pad sizes set to zero in x and y - ie they were still there but you could not see them.

Anyone had any experiences like this?

regards

Brian



Desktop EDA http://www.desktop-eda.com.au
Suite 26
2 Park Drive
Bundoora Vic 3083
Australia

ph +61 3 9455 2289 fax +61 3 9479 1675

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:proteledaforum@;techservinc.com
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:ForumAdministrator@;TechServInc.com
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@;techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to