Could be - I recently upgraded to an A3 printer, but have successfully
printed from both PCB and schematic since then.  Worth looking at though.

Thanks,

Andy

> -----Original Message-----
> From: Brad Velander [mailto:[EMAIL PROTECTED]
> Sent: 21 March 2003 16:53
> To: Protel EDA Forum
> Subject: Re: [PEDA] P99SE crash on opening schematic
>
>
> Andy,
>       I have seen similar difficulties with schematics in days
> gone by if you lost your printer connection. I know that you say
> you can still print PCB outputs but did your printer(s) in some
> way change recently (or your schematics are set to print on a
> different printer than PCB stuff)? Sorry I don't recall exactly
> how I recovered but maybe just playing with the Windows printer
> config will get things reset and working.
>
> Sincerely,
> Brad Velander.
>
> Lead PCB Designer
> Norsat International Inc.
> Microwave Products
> Tel   (604) 292-9089 (direct line)
> Fax  (604) 292-9010
> email: [EMAIL PROTECTED]
> http://www.norsat.com
>
>
> > -----Original Message-----
> > From: Andy Gulliver [mailto:[EMAIL PROTECTED]
> > Sent: Friday, March 21, 2003 1:20 AM
> > To: Protel EDA Forum
> > Subject: [PEDA] P99SE crash on opening schematic
> >
> >
> > I'm running P99SE/SP6 on an Athlon 1.2GHz with 1Gb RAM and
> > Windoze98SE.
> >
> > This setup has been running fine for months but now I get one
> > of a series of
> > errors of the 'invalid access'/'page fault' type whenever I
> > try and open or
> > create a schematic sheet.  This happens on old designs as
> > well.  PCB runs
> > fine, and I can print/post-process OK.  I use windows file
> > system for my
> > DDBs.
> >
> > I've tried an uninstall/reinstall of Protel to no effect.  There is no
> > obvious corruption of the Advsch99SE.ini file.
> >
> > Can anyone suggest anything else to try before I resort to
> > more drastic
> > measures (e.g. reformat the HDD!)?
> >
> > Regards,
> >
> > Andy Gulliver
>



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to