Within the configuration of Gerber and Drill file generation within Cam 
Manager, there is an option to set your origin for each of the drill or Gerber. The 
option is to use the absolute origin or the relative origin. Probably you have these 
set counter to each other and it is resulting in your drill and gerber files being 
offset from each other.
        If that is not the answer to your problem is probably that you have either a 
gerber or drill format error. i.e. gerber using 2.4 data, being read in as 2.3, 4.3 or 
some other significant digit problem. That same issue could effect the drill file as 
well.

Sincerely,
Brad Velander.

Lead PCB Designer
Norsat International Inc.
Microwave Products
Tel   (604) 292-9089 (direct line)
Fax  (604) 292-9010
email: [EMAIL PROTECTED]
http://www.norsat.com



> -----Original Message-----
> From: Website Visitor [mailto:[EMAIL PROTECTED]
> Sent: Monday, July 28, 2003 5:43 AM
> To: proteledaforum
> Subject: [PEDA] DESIGN EXPLORER 99 SE DRILL FILES
> 
> 
> Currently running Design Explorer SE Version 6.6.7 under 
> Windows 2000  service pack 2.
> 
> The NC Drill file (ASCII) coordinates do not match the Data Base.
> 
> Is there a way to correct this?
> 
> E-Mail address   [EMAIL PROTECTED]
> Posted from Association web site by: Ron Tupa


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to