In my experience, it depends on the volume of production.
  If large, best to see what the pcb house recommends to 
 get the best price... 
 If small then do it in gerber tool in such a way to minimize 
  setup time on the line etc etc...

 ralph garvin

-----Original Message-----
From: Tim Fifield [mailto:[EMAIL PROTECTED]
Sent: Tuesday, September 02, 2003 9:07 AM
To: Protel EDA Forum
Subject: [PEDA] Paneling


When making a panel is it best to do it in Protel or a gerber tool such as
Camtastic?

Tim Fifield





* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to