Hi, I wish to prevent a polygon from pouring in a certain area. I have used a fill as a keepout on that layer, but I then get DRC errors showing shorts where I have put the fill over tracks. I also get DRC clearance errors where the fill is under a component. Is there a neater way of doing this so it comes up DRC clean?
Regards Dave * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *