Hi Leo,
 that behaviour is ok. You can not give teh focus to a component in the pcb
 editor like you are used to in the schematic editor.

 Regards
Rolf Molitor
Ing.Buero i2e
Remscheid / Germany

> -----Urspr ngliche Nachricht-----
> Von: "Leo Potjewijd" <[EMAIL PROTECTED]>
> An: <[EMAIL PROTECTED]>
> Gesendet: Montag, 13. Oktober 2003 17:49
> Betreff: [PEDA] component focus
>
>
> > Hi all,
> >
> > for some reason I am not able to get a component in focus in the PCB
> editor
> > by just clicking on it.
> > For all other stuff (designators,  texts, pads, traces, etc) it works
OK.
> > Selecting (shift-click) a component works fine.
> >
> > Just for the record: the components are not locked; checking or
unchecking
> > the 'locked' checkbox does not make any difference.
> >
> > Obviously I am missing something obvious here, but I haven't a clue.....
> > Could any of you please point me in the right direction?
> >
> > Thanks,
> >
> > Leo Potjewijd
> > hardware designer
> > IE Keyprocessor bv.
> >
> > [EMAIL PROTECTED]
> > +31 20 4620700
> >
> >
>



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to