Try the 3-D viewr. One of the few reasons to use it. Flip the board
over and viola.

> -----Original Message-----
> From: Jon Elson [mailto:[EMAIL PROTECTED] 
> Sent: Friday, June 11, 2004 2:24 PM
> To: Protel EDA Forum
> Subject: Re: [PEDA] Viewing a mirrored bottom layer and other layers
> 
> 
> 
> bob stephens wrote:
> 
> >Well, I figured out a kind of crappy way to do it. In DXP you can 
> >selectively mirror Gerber layers. I turned off everything except the 
> >bottom layer and bottom overlay, both of which I mirrored and then I 
> >could look at them in Camtastic. Better than nothing.
> >  
> >
> Yup, you can do this in P99SE, too.  Write out the gerbers 
> mirrored, batch import them back in, and display from the 
> other side.  But, you lose a lot of information that way.  
> And, you might forget, and send the mirrored Gerber output to 
> the PCB maker, who might have no way to know something was 
> really wrong.
> 
> Jon
> 
> 
> 
> 


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to