Assuming you still have it, and EasyPC can generate Gerber files, then you can use 
Camtastics Reverse engineering capabilities to create a PCB from the Gerber.

Failing that, (if its only two layer) if you only have a paper print, or a bare PCB, 
then you could try scanning a bitmap, using a cad program similar to AutoCAD to draw 
lines over the pcb traces, then importing the autocad drawing into PCB one layer at a 
time.

Either of these methods will still require you to draw a schematic that matches the 
PCB.

There may be an easier, more direct way, but I last used EasyPC about fifteen years 
ago, I didn't even know it was still around!

j.


-----Original Message-----
From: Adeel Malik [mailto:[EMAIL PROTECTED]
Sent: 16 June 2004 09:04
To: 'Protel EDA Forum'
Subject: [PEDA] Importing EasyPCB fiels in Protel 99SE


I want to import PCB files routed in DOS-based EASYPCB Software in the Protel 99SE PCB 
Server. When I click the Import menu, the error message "Document Type Unknown" 
appears.
Can some one having the experience of importing EASYPCB files in PROTEL 99SE comment 
on it ?

Regards,
Adeel Malik




* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to