you cant make your own power symbols

but if you make a part with a pin (it can be very short)
you should get a hot spot
of course these parts would show in your BOM
but this is where 'include blank part value' checkbox 
comes in handy, should be acceptable

what do y'all use across the pond anyway ?


Dennis Saputelli


Leo Potjewijd wrote:
> 
> Hi,
> at the risk of asking an old question:
> Has anyone found a way to change the shape of the built-in power symbols of
> P99SE? We use different symbols here in Europe....
> I know I can build my own (I have a wide collection of them) but the lack
> of an electrical hotspot on these is (finally) getting to my nerves....
> 
> Leo Potjewijd
> hardware designer
> Integrated Engineering B.V.
> 
> [EMAIL PROTECTED]
> +31 20 4620700
> 
- 
_______________________________________________________________________
Integrated Controls, Inc.           Tel: 415-647-0480  EXT 107 
2851 21st Street                    Fax: 415-647-3003
San Francisco, CA 94110             www.integratedcontrolsinc.com




* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to