Hello,

I am looking for some info and help on a decent routing scheme for a 200+ pin PGA 
socket. I am using only a 2 sided board right now, but wondering if a 4 layer layout 
would be best. Customer wants to go low cost......

Seems you run out of routing room from the inside pins to the outside ones. Not much 
room to drop vias in. 

I thought I might have to pull out the center pins to put in vias, but run into the 
problems again, no routing room.

Any suggestions or visual aids?

Thanks from a new protel99 user!

Leif
[EMAIL PROTECTED]

Posted from Association web site by: Leif Erickson




* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to