Heh, nevermind.  I figured it out.  Apparently the documentation
points to an old config file and the correct config file to use is
openocd_lpc2148_v1257.cfg

Fixing the documentation to match.

Sarah

On Wed, Jan 28, 2009 at 10:51 PM, Sarah A Sharp <saharabe...@gmail.com> wrote:
> Unfortunately I don't think I have a 9V wall wort.  I'll look around...
>
> I'm running into an issue before I can even program the board.  I get
> the error message 'invalid command name "daemon_startup_attach"' when
> I try to run the command
>
> sudo /home/sarah/git/lpc-kit/LPC/2148/OCD/bin/openocd -s
> ../../../../Config/2148 -f openocd_lpc2148.cfg
>
> I'm trying to download the poke example to the board.  Jamey seems to
> think the config file is wrong for this version of openocd.  I used
> the psas OCD download script, and the version seems to be the same one
> recommended by the documentation:
>
>  $ openocd -v
> Open On-Chip Debugger 1.0 (2009-01-28-22:13) svn:1257
>
> Suggestions?
>
> Sarah
>
> On Wed, Jan 28, 2009 at 10:44 PM, Dave Camarillo
> <dave.camari...@gmail.com> wrote:
>> Hi Sarah, that pretty much correct. One interesting side thing is that
>> sometimes the olimex jtag programmer is unable to provide enough power
>> to the 2148 board, and you run into flashing problems. You can avoid
>> this by using a 9VDC wall wart. My hypothesis is that this stems from
>> the lack of current sourcing abilities of some laptops (mainly my
>> laptop), so it may also be mitigated by using a powered hub.
>>
>> Hope that's of some assistance...
>>
>> -dave
>>
>>
>> On Thu, Jan 29, 2009 at 6:36 AM, Sarah A Sharp <saharabe...@gmail.com> wrote:
>>> Hi Kay,
>>>
>>> Do these directions look right for the cabling/jumper setup for the
>>> LPC2148 board and Olimex OCD JTAG programmer?  I couldn't remember if
>>> there needs to be an other USB cable from the LPC2148 to the host PC
>>> or not when I'm trying to program the board.
>>>
>>> 1. Make sure to set the Olimex JTAG programmer to 9V by jumpering on
>>> the right-most pins (the two farthest away from the JTAG cable).
>>> 2. Plug a USB cable from the JTAG programmer to your computer.
>>> 3. Power the LPC2148 dev board by plugging it into the JTAG programmer
>>> with the white cable.
>>> 4. Make sure the LPC2148 debug jumper is jumpered (the DBG_E pins are
>>> next to the JTAG port)
>>> 5. Set both dip-switches on the LPC2148 board to the 'off' position.
>>>
>>> Did I miss anything?  I'm putting these directions into the
>>> documentation for the project, since they seem to be scattered between
>>> the Keil documentation, the Olimex schematic, and the PSAS wiki.
>>>
>>> Sarah Sharp
>>>
>>> _______________________________________________
>>> psas-avionics mailing list
>>> psas-avionics@lists.psas.pdx.edu
>>> http://lists.psas.pdx.edu/mailman/listinfo/psas-avionics
>>>
>>
>

_______________________________________________
psas-avionics mailing list
psas-avionics@lists.psas.pdx.edu
http://lists.psas.pdx.edu/mailman/listinfo/psas-avionics

Reply via email to