Hi Michael,

The meters in Pro Tools, as with all DAWs, are graphic representations that 
communicate several things at once. The meters always display the constantly 
changing value of the incoming or outgoing signal. VoiceOver can read this 
value with no problem. There's a setting in the Pro Tools preferences that 
toggles between no peak, 3-second peak and infinite peak hold. When peaks are 
displayed, VoiceOver reads the peak value instead of the dynamically changing 
level. With 3-second peak hold, of course, the value might change somewhat but 
will update over time every three seconds. With infinite peak hold, as you 
might imagine, the highest peak attained will display until it is manually 
reset. There's also a clip indicator that's separate from the level meter.

Although the VoiceOver doesn't read the level meters automatically but only the 
first time it encounters the meter and subsequently upon each query of what 
VoiceOver sees as being the meter's value, it's possible to set a hot spot on 
the fly at any given meter and have VoiceOver automatically speak the value 
whenever it changes. In the case of audio, this might be helpful, albeit only 
for a short while because Voiceover would continue to speak the constantly 
changing value all the time. While setting levels, this might be somewhat 
helpful although I think it would be more distracting than anything. while 
VoiceOver is focused on the meter, I would query the value with 
Control-Option-f3 several times to see what the general level is. If it's 
hovering around -30 dB, I'd boost the gain on the preamp and query the level 
meter again a few times. If the level is hovering around -2 dB, I'd turn the 
preamp down and query again until the meters are averaging around -18 to -15 
dB. After that, I'd move on to other tracks.

Setting levels is a subject beyond this list but, for what it's worth, people 
usually record way too hot, not only for their own good but for purposes of 
gain staging. For best results, average levels should be around -18 dB. At that 
level, there's plenty of headroom, a healthy signal-to-noise ratio, a low noise 
floor and absolutely no need to worry about clipping.

HTH,

Slau

On Jan 30, 2011, at 7:30 AM, Michael Kuhlmann wrote:

> Hi,
> 
> I'm new to this group and also new to protools. First of all, to introduce 
> myself: I'm working as a musician in church and I'm using a white macbook 
> with several audioprogramms. Now I would be interested to know, if there is a 
> possibility to have a refreshing levelmeter in protools. Within a recording I 
> would like to see the peakmeter permanently and when it is under the 
> vo-cursor it remains at the position where it was reached by the cursor. To 
> have a continuos control of the level it should refresh according to the 
> volume of the recording source. 
> 
> Any help would be very appreciated.
> 
> Thanks and kind regards
> 
> Michael

Reply via email to