I'll give that a try today.

On 2/6/2011 5:57 PM, Chuck Reichel wrote:
Hi HF,
Did you go to Pro Tools setup menu and the I/O dialogue then select your Input tab first.
Then follow these steps below.

Step1 Select all "command a"
Step2 find the delete path button and click it.
Step3 find the default button next and click it.
This should straighten out your inputs.
You can also do this for outputs and busses to.
Your mileage may very.
Talk soon
On Feb 6, 2011, at 2:34 PM, HF wrote:

Hi guys.

I just upgraded to PT 9 and installed the digi003 drivers separately as was instructed by the Avid website. Except that I don't see the digi003 in input selections. It defaulted to stereo1/2, stereo3/4 instead of the mono one's that I remember. In the audioMidi under utilities, it does list the digi003 but there is nothing that I can do to it. If I select it, it says that there is no device found for this. Don't remember the exact wording. I tried reinstalling the drivers to see if it would make a diference. It did not.

Any ideas?

HF

Chuck Reichel
954-742-0019
www.SoundPictureRecording.com



Reply via email to