On Mar 27, 2012, at 10:06 PM, Nick Gawronski wrote:
Hi, Is it possible to use both microphone and line in inputs one and two at the
same time and have them going to different tracks? How can I make sure my digi
003 is setup so the issue with the audio clock setting does not come up? If I
am going to use all analog inputs including microphones how many microphones
and line in inputs can I have routing to different tracks active at once? Nick
Gawronski
On 3/27/2012 8:09 PM, Slau Halatyn wrote:
On Mar 27, 2012, at 7:39 PM, Nick Gawronski wrote:
Hi, I just turned off and back on the 003 and pushed no other buttons. Does the
digi 003 save settings in it's internal memory if it has any? In the pro tools
hardware program it does say 44.1KHZ but it does not say how to change the
setting?
The 003 does not determine sample rate. sample rate is set when you create a session and,
therefore, cannot be changed on the fly. You'd have to use the "Save Copy In?"
command to save the session in a different sample rate.
Is analog outputs 1 and 2 the headphone plugs or does it automatically go to
them if I did not change any other settings and what inputs are the microphone
and normal line in ones so I know? Nick Gawronski
Anything routed to your main stereo pair will also show up on your headphone
jacks which are located at the front right bottom of the unit closest to you.
The Mic inputs are obviously the 4 XLR jacks and the line inputs are beneath
them and are quarter-inch jacks. You set the input selection on the 003 by
pushing the Mic/Line button below the gain knobs.
HTH,
Slau
