This is extremely similar to a question I had. So much so, I'm just gonna leave it in the same thread. How can we rename busses? Like said I wanted instead of a bus being called 1/2, I want it to be called control room speakers, etc. etc.

Chris.

----- Original Message ----- From: "Chi Kim" <[email protected]>
To: <[email protected]>
Sent: Tuesday, April 24, 2012 2:36 PM
Subject: IO Setup Renaming Paths


Hi,

I'm trying to use aggregate device on Pro Tools to combine my interface and soundflower. I set aggregate device as play engine. Then I went to io setup, and then inputs. I pressed cmd+a to select all and hit delete. I reset the paths by clicking default. I repeated that for output and bus as well. When I click ok, pro tools complains that there are more than one input path named input 1. How can I rename those conflicting path with VoiceOver? Or, is there way to rename those inputs outside of Pro Tools, so when I click default, Pro Tools would grab the names that don't conflict?
Thanks!

Chi


Reply via email to