Hi Jason, Could you post your "working with clip gain steps" we spoke about the other day? Always love those step by step kinda things! :) Saves a lot of time?
Chuck CHUCK REICHEL [email protected] www.SoundPictureRecording.com 954-742-0019 GUFFAWING :) In GOD I Trust On Feb 28, 2014, at 10:30 AM, studiojay wrote: > Hi Slau, Thanks a lot for your help. > Jason > > On Wednesday, February 26, 2014 6:29:47 PM UTC-4, Slau Halatyn wrote: > Hi Jason, > > Select the audio region that was punched in. While in Slip mode (f2), press > Option-minus on the num pad. This will open up the underlying audio by the > nudge value. So, if your nudge value is 100 milliseconds, the region start > will begin 100 milliseconds earlier. The plus key on the num pad will move > that edge later or to the right. So, Option-plus will reveal more of the > previously recorded audio while Option-minus will reveal more of the newly > recorded audio. Using Command as the modifier will do the same thing with the > end of the selected region. For all of the aforementioned shortcuts to work, > there must be a region selected. Otherwise, the only thing that's going to > happen is that you'll hear auditions of audio based on pre and post roll > value. > > HTH, > > Slau > > On Feb 26, 2014, at 2:56 PM, studiojay <[email protected]> wrote: > >> Hi everyone, >> When recording using quick punch mode in Pro Tools, if you miss the punch in >> point, you can trim back to get back the punch point after the recording >> pass since pro tools actually records from the time you press play, even >> before you actually press record. Can some one please tell me the command to >> trim back to recover the bad punch? Thanks in advance for any help. >> Jason >> >> -- >> You received this message because you are subscribed to the Google Groups >> "Pro Tools Accessibility" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected]. >> For more options, visit https://groups.google.com/groups/opt_out. > > > -- > You received this message because you are subscribed to the Google Groups > "Pro Tools Accessibility" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/groups/opt_out. -- You received this message because you are subscribed to the Google Groups "Pro Tools Accessibility" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
