Amazing, Slau. It worked greatly. Just for know, how works the trim automation in HD?
JP > On 3 Sep 2017, at 10:55, Slau Halatyn <slauhala...@gmail.com> wrote: > > I would say the best thing to do is to simply redo the automation in the > section you want. Make a selection of the range, turn on pre and post roll > and set the automation mode to Write. Make a pass and see if you're happy > with it. If not, set it to write mode again and repeat until you're satisfied. > Hope that helps. > >> On Sep 2, 2017, at 11:59 PM, Juan Pablo Culasso Alonso <jpcula...@gmail.com> >> wrote: >> >> Hi, Slau. >> Thanks for your explanation. >> >> Do you know other approach to achieve that? Really jump to a Hd version are >> not in the horizon. I tried with some fades but the ressult is too far that >> I need. >> >> JP. >>> On 2 Sep 2017, at 21:08, Slau Halatyn <slauhala...@gmail.com> wrote: >>> >>> JP, >>> This mode is called Trim mode and I think it's only available in HD. All >>> values are proportionally raised or lowered by whatever amount the fader is >>> moved in Trim Mode. There might be a way to visually select several volume >>> break points but I know of no way to do that without visually editing >>> within the timeline. >>> Slau >>> >>>> On Sep 2, 2017, at 10:36 AM, Juan Pablo Culasso Alonso >>>> <jpcula...@gmail.com> wrote: >>>> >>>> Hello all. >>>> >>>> I've been wondering this for quite some time now...I'm not even sure if >>>> it's possible. Let's say in the middle of mixing a track, I want to fade >>>> some selection down at a certain point, and then fade them back up. I'd >>>> normally do this with volume automation. However, let's say a week later I >>>> want to change the overall volume of that track, but keep the automation. >>>> Is this possible? Whenever I try to change the volume on a track where >>>> automation is written, it slides the fader back to its original position. >>>> I guess I'm wondering if there's a way to proportionaly keep the >>>> automation in relation to the volume changes. Any help would be greatly >>>> appreciated. Thanks >>>> JP >>>> >>>> -- >>>> You received this message because you are subscribed to the Google Groups >>>> "Pro Tools Accessibility" group. >>>> To unsubscribe from this group and stop receiving emails from it, send an >>>> email to ptaccess+unsubscr...@googlegroups.com. >>>> For more options, visit https://groups.google.com/d/optout. >>> >>> -- >>> You received this message because you are subscribed to the Google Groups >>> "Pro Tools Accessibility" group. >>> To unsubscribe from this group and stop receiving emails from it, send an >>> email to ptaccess+unsubscr...@googlegroups.com. >>> For more options, visit https://groups.google.com/d/optout. >> >> -- >> You received this message because you are subscribed to the Google Groups >> "Pro Tools Accessibility" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to ptaccess+unsubscr...@googlegroups.com. >> For more options, visit https://groups.google.com/d/optout. > > -- > You received this message because you are subscribed to the Google Groups > "Pro Tools Accessibility" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to ptaccess+unsubscr...@googlegroups.com. > For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Pro Tools Accessibility" group. To unsubscribe from this group and stop receiving emails from it, send an email to ptaccess+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.
