Hello guys, For some reason these messages went in my junk folder.
I will have to look at flow tools as I get back into upgrading the setup. I did not know if I could use the 003 strictly as a controller, I don’t want to run my interface through VIA the 003 optical because I will still be hampered by the fire wire limitations, and I want to be able to take advantage of thunderbolt speed. If I can use both then I would probably consider keeping the 003 as the controller. Nate Kile, Assistive Technology Instructor, Tech Vision Specialist in Technology/Training/Teaching for blind/low vision/virtual instruction for schools Also Private training to your needs 907-444-3707 Website with hundreds of informational articles & lessons on PC, Office products, Mac, iPad/iTools and more, all done with keystrokes: <http://www.yourtechvision.com> www.yourtechvision.com From: [email protected] [mailto:[email protected]] On Behalf Of TheOreoMonster Sent: Saturday, October 21, 2017 5:14 PM To: [email protected] Subject: Re: Running a project studio without a control surface? Unless you are selling the 003 to fund other upgrades, Can yo u not still use it as a surface even if you don’t use its interface? On Oct 21, 2017, at 3:26 PM, Nathaniel Kile <[email protected] <mailto:[email protected]> > wrote: Hello everyone, I am in the process of reopening my project studio. In the past I always had a control surface, I still have my 003, but am going to be moving on and upgrading, I don’t want to lose the efficiency and workflow that I gained with the surface, does anyone have any thoughts on this? Has anyone sacrificed the surface and found workflow still as efficient? Thanks for any thoughts, Nate Kile, Assistive Technology Instructor, Tech Vision Specialist in Technology/Training/Teaching for blind/low vision/virtual instruction for schools Also Private training to your needs 907-444-3707 Website with hundreds of informational articles & lessons on PC, Office products, Mac, iPad/iTools and more, all done with keystrokes: <http://www.yourtechvision.com/> www.yourtechvision.com -- You received this message because you are subscribed to the Google Groups "Pro Tools Accessibility" group. To unsubscribe from this group and stop receiving emails from it, send an email to <mailto:[email protected]> [email protected]. For more options, visit <https://groups.google.com/d/optout> https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Pro Tools Accessibility" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected] <mailto:[email protected]> . For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Pro Tools Accessibility" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
