Thanks Juergen, i will give a try. regards suresh
On Mon, May 31, 2010 at 1:33 PM, Juergen Beisert <[email protected]> wrote: > Suresh, > > Suresh Kumar wrote: >> I have purchased the ATMEL AT91RM9200 Mircrocontroller Development >> Board from kwik byte. And i didnt get the BSP software for the board. >> >> I am using ptxdist for build tool and successfully able to build the >> linux,and packages.And able to boot board via tftp with the newly >> built image. >> >> But i am intersted to manipulate the the devices (LEDs, Parallel >> ports,etc). unfortunately i didnt get the BSP from the vendor. >> >> I guess ptxdist has the BSP for ARM. can you little elaborate this. >> Where to refer , how to use, how to compile, etc > > Its not ptxdist specific, its kernel specific instead: You have to enable the > drivers for this kind of hardware on your target in the kernel configuration. > > When I run 'menuconfig' in the current kernel, I found the "[*] KwikByte > KB920x" platform. It seems, everything (or most) you need is present in the > plain vanilla kernel. Maybe the 'arch/arm/configs/kb9202_defconfig' > and 'arch/arm/mach-at91/board-kb9202.c' could be a starting point for you. > > Regards, > Juergen > > -- > Pengutronix e.K. | Juergen Beisert | > Linux Solutions for Science and Industry | Phone: +49-8766-939 228 | > Vertretung Sued/Muenchen, Germany | Fax: +49-5121-206917-5555 | > Amtsgericht Hildesheim, HRA 2686 | http://www.pengutronix.de/ | > -- ptxdist mailing list [email protected]
