Hello, I was told that git repository from pengutronix has the more current support for the freescale MX28.
I am using Freescale reference board and not having any luck getting the 3.1 to run on this board. However I can run 2.6.35 kernel on this board just fine. Should top of the git repo on pengutronix work for MX28 EVK board? I have not included boot log because there is nothing much to show, u-boot loads the kernel, decompresses and says "Starting kernel" and I don't see any output on the console. As mentioned above using same u-boot and same u-boot bootargs 2.6.35 kernel boots just fine. BTW, if this is not the right forum to ask this question would appreciate a pointer to right mailing list Regards, -Sam -- ptxdist mailing list [email protected]
