Hello Sam,
> I was told that git repository from pengutronix has the more current
> support for the freescale MX28.
Most relevant things should be in mainline. You might need
http://mid.gmane.org/[email protected]
though.
> I am using Freescale reference board and not having any luck getting
> the 3.1 to run on this board.
>
> However I can run 2.6.35 kernel on this board just fine. Should top of
v2.6.35 doesn't even have arch/arm/mach-mxs so I guess you mean the
Freescale kernel. They are not really comparable.
> the git repo on pengutronix work for MX28 EVK board?
>
> I have not included boot log because there is nothing much to show,
> u-boot loads the kernel, decompresses and says "Starting kernel" and I
> don't see any output on the console. As mentioned above using same
> u-boot and same u-boot bootargs 2.6.35 kernel boots just fine.
What is your kernel command line? With vanilla you need
console=ttyAMA0,...
If that doesn't help try enabling DEBUG_LL and EARLY_PRINTK.
> BTW, if this is not the right forum to ask this question would
> appreciate a pointer to right mailing list
I'd recommend
[email protected]
and Cc: [email protected] and Shawn Guo <[email protected]>.
Best regards
Uwe
--
Pengutronix e.K. | Uwe Kleine-König |
Industrial Linux Solutions | http://www.pengutronix.de/ |
--
ptxdist mailing list
[email protected]
