Hello Guys,
I don't know if this is relevant but I thought I would chime in.
This is one is for Network Bonding in Proxmox -> Nic Bonding in Proxmox
<https://www.youtube.com/watch?v=auMugO3zsKw>
This one is Bond Nics w/VLan Support in Proxmox
<https://www.youtube.com/watch?v=nIip66Rzt4I>
I apologize if this is not what you were wanting.
Thanks,
Michael
On 7/16/23 12:44 AM, Timo Veith wrote:
Am 15.07.2023 um 22:43 schrieb Arjen via pve-user<[email protected]>:
Von: Arjen <[email protected] <mailto:[email protected]>>
Betreff: Aw: [PVE-User] vlan setup at time of host installation
Datum: 15. Juli 2023 um 22:43:37 MESZ
An: Proxmox VE user list <[email protected]
<mailto:[email protected]>>
------- Original Message -------
On Saturday, July 15th, 2023 at 22:25, Timo Veith <[email protected]
<mailto:[email protected]>> wrote:
Dear pve users,
I am totally new to pve. Is there a recommended way to setup vlans during the
installation of a host? I have found some notes about vlans in the
documentation but it only describes some sections in /etc/network/interfaces
but it doesn’t say when this should be done. In fact I did one of the proposed
methods and I can connect to the management ip address in that vlan but I
wonder if it was right how I did it. I installed from the iso, configured some
ip because I didn’t find any option for using vlans in the installer and then
searched through the documentation. I changed the /etc/network/interfaces and
did a reboot. Where after I was able to connect to the ip address that I
configured. However in the console I can still read „use blabla ip and port
8006“ which is the ip I used during the installation.
Cheers
Timo
Don't panic; you did nothing wrong. The installer is rather simple and only
does the basic installation.
It's common to setup more complex things (like vlan) after installation. If the
Proxmox GUI does not support it, or is not (yet) reachable, you do those things
on the Proxmox console.
The console welcome message probably takes the IP address from /etc/hosts,
which you also need to manually adjust to match the new IP.
Best regards
Hello Arjen,
thank you for your reply.
I understand. Do you have some more common examples of cases where you can only
configure that after the GUI installation and with the console?
Greetings
Timo
_______________________________________________
pve-user mailing list
[email protected]
https://lists.proxmox.com/cgi-bin/mailman/listinfo/pve-user
--
*Michael Cooper*
/Systems Engineer/
Coopfire Services <http://www.coopfire.com>
_______________________________________________
pve-user mailing list
[email protected]
https://lists.proxmox.com/cgi-bin/mailman/listinfo/pve-user
