________________________________________ De: [email protected] [[email protected]] en nombre de Marco Gabriel - inett GmbH [[email protected]] Enviado el: miércoles, 26 de junio de 2013 8:57 Para: Ben Hambleton; [email protected] Asunto: Re: [PVE-User] Can not build cluster in 3.0
> Hello. I have been following the instructions in > http://pve.proxmox.com/wiki/Proxmox_VE_2.0_Cluster to create a cluster on the > same subnet with private IPs. I have made sure the hosts files are correct, > and time is synced. However when I log into the second node and run pvecm add > IP-ADDRESS-CLUSTER the following happens: > will just sit there for ages and do nothing. I have reformatted and > reinstalled the node again and the same thing happens. Am I missing > something? Any idea as to where to look would be greatly appreciated. You should check that - Multicast works (Switch configuration) - there is no firewall between the pve hosts that blocks corosync traffic If Multicast does not work, you can try to reconfigure corosync to use UDP unicast. You can find an example on your PVE node at /usr/share/doc/corosync-pve/examples/corosync.conf.example.udpu Best regards, Marco Helo, It happens the same here. Multicast has been tested succesfully following this: http://pve.proxmox.com/wiki/Multicast_notes#test_if_multicast_is_working_between_two_nodes_with_omping So I guess I don't have to configure anything on the switch.... No firewall blocking anything. /etc/pve/cluster.conf succesfully replicated, but on the GUI of the first node the nodes appears with a red indicartor and I cannot get properties from them. Any clue? Kind regards, Angel Docampo _______________________________________________ pve-user mailing list [email protected] http://pve.proxmox.com/cgi-bin/mailman/listinfo/pve-user
