Hi Daniel, which Proxmox version are you using? Did you do a reboot or just a restart of the networking.service (PVE 4.1)? The restart of the service doesn't always work. Please try with a reboot.
Cheers, Alwin On 05/20/2016 02:37 PM, Daniel Eschner wrote: > Hi there, > > i still made a small Proxmox Cluster with 2 bonding interfaces. Here is my > Config: > > > auto lo > iface lo inet loopback > > iface eth0 inet manual > > iface eth1 inet manual > > auto bond0 > iface bond0 inet manual > slaves eth0 eth1 > bond_miimon 100 > bond_mode active-backup > > auto vmbr0 > iface vmbr0 inet static > address 10.0.2.110 > netmask 255.255.255.0 > gateway 10.0.2.1 > broadcast 10.0.2.255 > bridge_ports bond0 > bridge_stp off > bridge_fd 0 > bridge_maxwait 0 > bridge_maxage 0 > bridge_ageing 0 > > > I got tons of error Messages in the Kernel log: > > May 20 14:36:08 host01 kernel: [ 472.234199] vmbr0: received packet on bond0 > with own address as source address > May 20 14:36:09 host01 kernel: [ 472.596063] vmbr0: received packet on bond0 > with own address as source address > May 20 14:36:09 host01 kernel: [ 472.957862] vmbr0: received packet on bond0 > with own address as source address > May 20 14:36:09 host01 kernel: [ 473.319847] vmbr0: received packet on bond0 > with own address as source address > May 20 14:36:10 host01 kernel: [ 473.681891] vmbr0: received packet on bond0 > with own address as source address > May 20 14:36:10 host01 kernel: [ 474.043746] vmbr0: received packet on bond0 > with own address as source address > > > I changed the Mode from bond-mode rr to active-backup but i see the same > erros. > > root@host01:~# cat /proc/net/bonding/bond0 > Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011) > > Bonding Mode: load balancing (round-robin) > MII Status: up > MII Polling Interval (ms): 100 > Up Delay (ms): 0 > Down Delay (ms): 0 > > Slave Interface: eth0 > MII Status: up > Speed: 1000 Mbps > Duplex: full > Link Failure Count: 0 > Permanent HW addr: 0c:c4:7a:aa:5b:ce > Slave queue ID: 0 > > Slave Interface: eth1 > MII Status: up > Speed: 1000 Mbps > Duplex: full > Link Failure Count: 0 > Permanent HW addr: 0c:c4:7a:aa:5b:cf > Slave queue ID: 0 > > This funny think is - it shows round-robin anyway :-( > > Any ideas what it can be happen? I already rebooted the System ;) > > Cheers > > Daniel > > > _______________________________________________ > pve-user mailing list > [email protected] > http://pve.proxmox.com/cgi-bin/mailman/listinfo/pve-user > _______________________________________________ pve-user mailing list [email protected] http://pve.proxmox.com/cgi-bin/mailman/listinfo/pve-user
