Hi,
We have just upgraded to proxmox 4.3-1/e7cdc165. Loving the new layout,
and the new icon is nice too. Thanks for a great product! :-)
The s.m.a.r.t info is a nice new addition, however... it's not working
for us. In the gui we're getting: "UNKNOWN" and the button "show smart
values" gives us: "No SMART values".
However, from cli:
root@proxmox:~# smartctl -i /dev/sda
smartctl 6.4 2014-10-07 r4002 [x86_64-linux-4.4.19-1-pve] (local build)
Copyright (C) 2002-14, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Vendor: SEAGATE
Product: ST4000NM0034
Revision: E001
Compliance: SPC-4
User Capacity: 4,000,787,030,016 bytes [4.00 TB]
Logical block size: 512 bytes
Physical block size: 4096 bytes
LB provisioning type: unreported, LBPME=0, LBPRZ=0
Rotation Rate: 7200 rpm
Form Factor: 3.5 inches
Logical Unit id: 0x5000c50084fafde3
Serial number: Z4F0MSVA0000R628SWTU
Device type: disk
Transport protocol: SAS (SPL-3)
Local Time is: Mon Oct 3 14:46:34 2016 CEST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
Temperature Warning: Enabled
root@proxmox:~#
Same goes for the other disks. The disks are simple nearline sas (sata)
disks.
Is there something we need to do, to enable the smart system within
proxmox perhaps?
Best regards,
MJ
_______________________________________________
pve-user mailing list
[email protected]
http://pve.proxmox.com/cgi-bin/mailman/listinfo/pve-user
