On Thursday 17 July 2008 16:06:24 Nat Tellin wrote: > HVR-1950 support seems to be a bit new. I had to compile from a > snapshot to get a working module. > > The meat of the device seems to be detected ok. Still getting MythTV > set up though. > > My issue is that no IR device gets created. > tveeprom 1-00a2: has radio, has IR receiver, has IR transmitter > from dmesg looks promising, but there are no i2c or lirc related > messages after that, and nothing shows up in /dev. > > This unit just arrived today. Maybe they're playing revision games > again or maybe I'm missing something obvious. > > What info would you like or what should I try? > > Thanks. > _______________________________________________ > pvrusb2 mailing list > [email protected] > http://www.isely.net/cgi-bin/mailman/listinfo/pvrusb2
Hello Nat, Other than the IR device, did you get the digital part to work under MythTV? I'm using the vanilla 2.6.25.4 kernel and compiled the snapshot from v4l-dvb separately. All the modules seem to load successfully and the analog part works without any problems but the digital part partially works. It can only scan about 4 over-the-air channels and it only successfully tunes into a channel 1 out of 10 times. And even when it does succeed, it takes around 3 minutes to lock in. I know it's not a broadcast signal problem because I have another PCI digital tuner that works just fine. Please let me know if you have a common problem. Thanks, Yusik _______________________________________________ pvrusb2 mailing list [email protected] http://www.isely.net/cgi-bin/mailman/listinfo/pvrusb2
