--- On Wed, 12/2/09, Mike Isely <[email protected]> wrote: > > > > The device name seems to be /dev/video1. When I > try "mplayer /dev/video1" it tells me No such file or > directory. Same for video0. > > How do you know it is /dev/video1?
I typed "ls /dev" before and after plugging in the PVR and video1 was the new name in the list. I know there's probably a better way to check, but I'm new to linux and learning. > > What does the kernel log tell you? (Try dmesg.) > You should see a bunch > of log messages from the kernel as the driver comes > up. If it fails to > initialize properly the clues for why will be there as > well. > > -Mike Thanks for the reply. I'll paste the dmesg output below. It looks like it's getting stuck on "requesting v4l-cx2341x-enc.fw". I confirmed the file with that name is in my firmware directory. Robert [ 128.492083] usb 2-4: new high speed USB device using ehci_hcd and address 3 [ 128.629132] usb 2-4: configuration #1 chosen from 1 choice [ 128.758834] usbcore: registered new interface driver pvrusb2 [ 128.758841] pvrusb2: V4L in-tree version:Hauppauge WinTV-PVR-USB2 MPEG2 Encoder/Tuner [ 128.758847] pvrusb2: Debug mask is 31 (0x1f) [ 129.756192] usb 2-4: firmware: requesting v4l-pvrusb2-24xxx-01.fw [ 129.783918] pvrusb2: Device microcontroller firmware (re)loaded; it should now reset and reconnect. [ 129.804585] usb 2-4: USB disconnect, address 3 [ 129.805109] pvrusb2: Device being rendered inoperable [ 131.560110] usb 2-4: new high speed USB device using ehci_hcd and address 4 [ 131.696824] usb 2-4: configuration #1 chosen from 1 choice [ 131.779314] cx25840' 4-0044: cx25843-24 found @ 0x88 (pvrusb2_a) [ 131.859076] tuner' 4-0043: chip found @ 0x86 (pvrusb2_a) [ 131.873048] tda9887 4-0043: creating new instance [ 131.873053] tda9887 4-0043: tda988[5/6/7] found [ 131.903931] tuner' 4-0061: chip found @ 0xc2 (pvrusb2_a) [ 131.909193] wm8775' 4-001b: chip found @ 0x36 (pvrusb2_a) [ 131.946692] pvrusb2: Device has newer IR hardware; disabling unneeded virtual IR device [ 131.966956] tveeprom 4-00a2: Hauppauge model 24022, rev E1A3, serial# 8675772 [ 131.966963] tveeprom 4-00a2: tuner model is TCL MFNM05-4 (idx 103, type 43) [ 131.966969] tveeprom 4-00a2: TV standards NTSC(M) (eeprom 0x08) [ 131.966973] tveeprom 4-00a2: audio processor is CX25843 (idx 37) [ 131.966978] tveeprom 4-00a2: decoder processor is CX25843 (idx 30) [ 131.966982] tveeprom 4-00a2: has radio, has IR receiver, has IR transmitter [ 131.966991] pvrusb2: Supported video standard(s) reported available in hardware: PAL-M/N/Nc;NTSC-M/Mj/Mk [ 131.966999] pvrusb2: Mapping standards mask=0xb700 (PAL-M/N/Nc;NTSC-M/Mj/Mk) [ 131.967004] pvrusb2: Setting up 6 unique standard(s) [ 131.967009] pvrusb2: Set up standard idx=0 name=PAL-M [ 131.967014] pvrusb2: Set up standard idx=1 name=PAL-N [ 131.967018] pvrusb2: Set up standard idx=2 name=PAL-Nc [ 131.967023] pvrusb2: Set up standard idx=3 name=NTSC-M [ 131.967027] pvrusb2: Set up standard idx=4 name=NTSC-Mj [ 131.967031] pvrusb2: Set up standard idx=5 name=NTSC-Mk [ 131.967037] pvrusb2: Initial video standard guessed as NTSC-M [ 131.967049] pvrusb2: Device initialization completed successfully. [ 131.967152] pvrusb2: registered device video1 [mpeg] [ 131.967194] pvrusb2: registered device radio0 [mpeg] [ 131.986226] cx25840' 4-0044: firmware: requesting v4l-cx25840.fw [ 134.208427] cx25840' 4-0044: loaded v4l-cx25840.fw firmware (16382 bytes) [ 134.386042] tuner-simple 4-0061: creating new instance [ 134.386049] tuner-simple 4-0061: type set to 43 (Philips NTSC MK3 (FM1236MK3 or FM1236/F)) [ 134.464798] cx25840' 4-0044: Video signal: not present [ 134.464803] cx25840' 4-0044: Detected format: NTSC-M [ 134.464807] cx25840' 4-0044: Specified standard: NTSC-M [ 134.464812] cx25840' 4-0044: Specified video input: Composite 7 [ 134.464816] cx25840' 4-0044: Specified audioclock freq: 48000 Hz [ 134.471946] cx25840' 4-0044: Detected audio mode: forced mode [ 134.471952] cx25840' 4-0044: Detected audio standard: no detected audio standard [ 134.471957] cx25840' 4-0044: Audio muted: no [ 134.471961] cx25840' 4-0044: Audio microcontroller: detecting [ 134.471965] cx25840' 4-0044: Configured audio standard: automatic detection [ 134.471970] cx25840' 4-0044: Configured audio system: BTSC [ 134.471974] cx25840' 4-0044: Specified audio input: Tuner (In8) [ 134.471978] cx25840' 4-0044: Preferred audio mode: stereo [ 134.471984] tda9887 4-0043: Data bytes: b=0x14 c=0x30 e=0x44 [ 134.471989] tuner' 4-0061: Tuner mode: analog TV [ 134.471993] tuner' 4-0061: Frequency: 175.25 MHz [ 134.471997] tuner' 4-0061: Standard: 0x00001000 [ 134.472002] wm8775' 4-001b: Input: 2 [ 134.472016] usb 2-4: firmware: requesting v4l-cx2341x-enc.fw [ 178.856736] wlan0: beacon loss from AP ffff88013c978ac0 - sending probe request [ 258.833277] wlan0: beacon loss from AP ffff88013c978ac0 - sending probe request [ 358.778790] wlan0: beacon loss from AP ffff88013c978ac0 - sending probe request [ 478.799118] wlan0: beacon loss from AP ffff88013c978ac0 - sending probe request [ 718.831722] wlan0: beacon loss from AP ffff88013c978ac0 - sending probe request _______________________________________________ pvrusb2 mailing list [email protected] http://www.isely.net/cgi-bin/mailman/listinfo/pvrusb2
