All ideas are welcome!

I followed the directions on blushingpenguin and have to be close....

The lircd.conf is an issue. When I start lirc with the file,
    (mark/lmark/lircd.conf)

Dec 17 15:38:16 box lircd-0.8.6[1263]: caught signal
Dec 17 15:38:18 box lircd-0.8.6[2234]: error in configfile line62:
Dec 17 15:38:18 box lircd-0.8.6[2234]: "2147549184": must be a valid (lirc_t) number


If I remove all the 'larger codes' then the file loads. When I test w/ irsend
   irsend SEND_ONCE blaster <CODE_GOES_HERE>
I get an error:

Dec 17 16:15:59 box kernel: lirc_zilog: i2c_master_recv failed with -5 -- keeping last read buffer Dec 17 16:15:59 box kernel: lirc_zilog: i2c_master_recv failed with -5 -- keeping last read buffer
Dec 17 16:16:12 box lircd-0.8.6[2479]: caught signal



It appears to load everything ok

Dec 17 15:31:41 box kernel: lirc_dev: IR Remote Control driver registered, major 249 Dec 17 15:31:41 box kernel: lirc_zilog: Zilog/Hauppauge IR driver initializing
Dec 17 15:31:41 box kernel: lirc_zilog: chip found with RX and TX
Dec 17 15:31:41 box kernel: i2c-adapter i2c-0: lirc_dev: driver lirc_zilog registered at minor = 0 Dec 17 15:31:41 box kernel: Zilog/Hauppauge i2c IR 0-0071: firmware: requesting haup-ir-blaster.bin Dec 17 15:31:41 box avahi-daemon[1090]: Service "f12-hdpvr-190" (/services/ssh.service) successfully established. Dec 17 15:31:41 box kernel: lirc_zilog: Zilog/Hauppauge IR blaster firmware version 2.1.0 loaded
Dec 17 15:31:41 box kernel: lirc_zilog: initialization complete
Dec 17 15:31:42 box lircd-0.8.6[1263]: lircd(default) ready, using /var/run/lirc/lircd

--
greg at pryzby dot org
BLOG: http://restonartistree.blogspot.com/
WEB:  http://www.RestonArtisTree.com/
      http://www.iceflowskating.com/
TWTR: gpryzby
_______________________________________________
pvrusb2 mailing list
[email protected]
http://www.isely.net/cgi-bin/mailman/listinfo/pvrusb2

Reply via email to