This series of patches includes support, tests and fixes for
adding PCA9552 and PCA9554 I2C devices to the powernv10 chip.
The PCA9552 device is used for PCIe slot hotplug power control
and monitoring, while the PCA9554 device is used for presence
detection of IBM CableCard devices. Both devices are required
by the Power Hypervisor Firmware on Power10 platforms.
Changes from previous version:
- Added prerequisite patch that hasn't merged into master yet.
(see patch 1/8 for details). Without this patch, the code
compiles but "make check" fails.
Glenn Miles (8):
ppc/pnv: Add pca9552 to powernv10 for PCIe hotplug power control
ppc/pnv: Wire up pca9552 GPIO pins for PCIe hotplug power control
ppc/pnv: PNV I2C engines assigned incorrect XSCOM addresses
ppc/pnv: Fix PNV I2C invalid status after reset
ppc/pnv: Use resettable interface to reset child I2C buses
misc: Add a pca9554 GPIO device model
ppc/pnv: Add a pca9554 I2C device to powernv10
ppc/pnv: Test pnv i2c master and connected devices
MAINTAINERS | 2 +
hw/misc/Kconfig | 4 +
hw/misc/meson.build | 1 +
hw/misc/pca9554.c | 328 ++++++++++++++++
hw/ppc/Kconfig | 2 +
hw/ppc/pnv.c | 35 +-
hw/ppc/pnv_i2c.c | 47 ++-
include/hw/misc/pca9554.h | 36 ++
include/hw/misc/pca9554_regs.h | 19 +
tests/qtest/meson.build | 1 +
tests/qtest/pnv-host-i2c-test.c | 653 ++++++++++++++++++++++++++++++++
11 files changed, 1106 insertions(+), 22 deletions(-)
create mode 100644 hw/misc/pca9554.c
create mode 100644 include/hw/misc/pca9554.h
create mode 100644 include/hw/misc/pca9554_regs.h
create mode 100644 tests/qtest/pnv-host-i2c-test.c
--
2.31.1
